Ahhh better idea. Monroe > -------- Original Message -------- > Subject: [AR] Re: Larger size motor case liners > From: Wedge Oldham <wedgeoldham@xxxxxxxxx> > Date: Wed, October 16, 2013 3:51 pm > To: arocket@xxxxxxxxxxxxx > > > Pat, Jeff Taylor, and a large number of other can all get 6" phenolic > liners. Ask on the Tripoli list. > > On Wed, Oct 16, 2013 at 1:51 PM, Greg Deputy <greg@xxxxxxxxxxxxx> wrote: > > I’m flying a 152mm 2 grain motor in a couple weeks, first tested years ago. > > Case is 6061-t6, liner is cardboard wrapped with 1/16”epdm sheet. I can’t > > recall ever seeing phenolic liners in the 6”size. Would have to be a custom > > item. > > > > > > > > From: arocket-bounce@xxxxxxxxxxxxx [mailto:arocket-bounce@xxxxxxxxxxxxx] On > > Behalf Of Bill Claybaugh > > Sent: Wednesday, October 16, 2013 1:18 PM > > To: arocket@xxxxxxxxxxxxx > > Cc: Arocket List > > Subject: [AR] Re: Larger size motor case liners > > > > > > > > Cases--which are also the airframe--are 6061-T6; liner is cast in place > > EPDM. Grain is a center burning finocyl, also cast in place. > > > > > > > > Bill > > > > Sent from my iPhone > > > > > > On Oct 16, 2013, at 15:56, Daryle Dismukes <daryled@xxxxxxxxx> wrote: > > > > Those of you who are working with fuel grains in the 150mm / 5.5-6 inch > > diameter range, what are you using for your motor cases and liners? The > > largest I've done before is 98mm, and I used as much off the shelf Aerotech > > hardware as I could. Now I need to do something larger in a hurry at work > > and I'm hoping to find a source of pre-made carbon phenolic tubes between > > 5.5 to 6 inches in diameter. Any sources or ideas? Other things to try? > > > > -Daryle