Thanks Bill. I started off assuming the cases should be reusable, but your solution of casting in place would work much better overall. Thanks again. -Daryle On Oct 16, 2013 1:18 PM, "Bill Claybaugh" <wclaybaugh2@xxxxxxxxxx> wrote: > Cases--which are also the airframe--are 6061-T6; liner is cast in place > EPDM. Grain is a center burning finocyl, also cast in place. > > Bill > > Sent from my iPhone > > On Oct 16, 2013, at 15:56, Daryle Dismukes <daryled@xxxxxxxxx> wrote: > > Those of you who are working with fuel grains in the 150mm / 5.5-6 inch > diameter range, what are you using for your motor cases and liners? The > largest I've done before is 98mm, and I used as much off the shelf Aerotech > hardware as I could. Now I need to do something larger in a hurry at work > and I'm hoping to find a source of pre-made carbon phenolic tubes between > 5.5 to 6 inches in diameter. Any sources or ideas? Other things to try? > > -Daryle > >