You should reconsider using Hydrogen, ISP below 3-D printed parts
temperature is the best, better than Helium. With Liquid Hydrogen, you can
run the heater tube in the flow of the fan, to get the high pressure
hydrogen up to Room Temperature.
Uwe, it's a cool 3-D printed design, are the print files Open Source? Joe,
is your design proprietary or open?
https://youtu.be/3FLV0EjmUzo?t=614
On Sun, Dec 15, 2019 at 8:01 PM Joe Barnard <joe@bps.space> wrote:
Yeah, Hydrogen was never in the running for anything I’ve ever done.
I know this is somewhat sacrilege for this email list but the point of
having an afterburner on this hopper vehicle is that it looks cool, not
that I want extra thrust. I don’t have the experience to comfortably
build/use/fly a liquid biprop, so dumping butane/propane out the back of an
EDF is the next best thing.
On Sun, Dec 15, 2019 at 9:39 PM Charlie Garcia <dragonrider.hhcc@xxxxxxxxx>
wrote:
I did in fact run a demo at a science museum for 5 years using hydrogen
gas and a pringles can. I can proudly report that after this experience, I
still have all my fingers.
For an afterburner running at a pc of ~ 0 (like the one on Sprite) and
with no contraction ratio, there is no reason to use hydrogen.
On Sun, Dec 15, 2019 at 10:34 PM Craig Fink <webegood@xxxxxxxxx> wrote:
On Sun, Dec 15, 2019 at 7:31 PM Charlie Garcia <
dragonrider.hhcc@xxxxxxxxx> wrote:
Speaking as a good friend of Joe's,
Nothing Joe does should be construed as rated for spaceflight.
Also speaking as a good friend of Joe's:
If you're reading this Joe, dear god don't use hydrogen, I like you in
you unexploded state...
Did you use Hydrogen recently?
On Sun, Dec 15, 2019 at 8:50 PM Craig Fink <webegood@xxxxxxxxx> wrote:
https://youtu.be/AkXZcNObUIc?t=47
Uwe, BPS.space 3D printed with heat shielding for the hot section.
BPS.space use Hydrogen not Propane, your rig looks supersonic ready.
Hydrogen can erase the SoundBarrier to get your Engine Supersonic for
testing.
ping ping ... did you see this video?
https://www.youtube.com/watch?v=AkXZcNObUIc
??
On Wed, Dec 11, 2019 at 1:01 AM Uwe Klein <uwe@xxxxxxxxxxxxxxxxxxx>
wrote:
pingAttachments area
Preview YouTube video TVC Vane Alignment
TVC Vane Alignment
<https://www.youtube.com/watch?v=AkXZcNObUIc&authuser=0>
--
Craig Fink
WeBeGood@xxxxxxxxx
--
Craig Fink
WeBeGood@xxxxxxxxx
